Paul, This is all I have related to convergence. From Tech Repair CD: Sharp\55RWP4H\Goes into convergence mode by itself* then locks up and cannot turn off unit\\\\Replace convergence driver unit PWB-P (DUNTKA244WEV0)* part of chassis swap program\\\\\\\\ Jeff -- Intrepid Video TV/VCR Repair 263 S Front St, Steelton PA 17113 717-939-7708; (F) 717-564-4952 www.intrepid-video.com www.tech-repair.net ----- Original Message ----- From: "Paul" <dntwntv@xxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Thursday, August 05, 2004 2:17 PM Subject: [TechAssist] Sharp 55R-WP5 Proj TV Is anyone familiar with this set? Maybe a sharp asc? The question is about the digital convergence unit. All tests point to this being the problem for a no start condition. The +5v line is being pulled down to 1or 2v. By disconnecting pins 3&4 of connector 610, that supply the 5v to the d.u.,the voltage is 4.9v. Seems obvious but I have seen obvious turn out to be something else.This unit cost $262 + so do not want to be wrong. Has anyone had this problem or had to replace the digital convergence unit on this set before? Have been unable to find anyone with this information yet. Hope some here can help. Paul Paul ,B Central TV&Video 911W Grand Ave Grover Beach Ca. (805)481-8084 ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/