Original Problem: Sanyo DS27930 Dead set Repair included: Vertical IC IC501 LA7849 H.Out. Q402 2SD2645 R463 - 3.3 ohm, 2 w R483 - 1 ohm, 1/2 w D501 - 75 v. zener D483 - subbed 1N4936 C487 1000 uf / 35 v. This enabled TV to power on, but had sides bowed in and IC501 would run very hot. Replaced D461 - subbed with 1N4936 TV now works good again. Wally Heise South Isle Repair Isle, Mn. ----- Original Message ----- From: "Wally Heise" <sirepair@xxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Thursday, January 19, 2006 1:13 PM Subject: [TechAssist] Sanyo DS27930 need zener diode value > Hello, > I need the value of Zener Diode D502. It is located in the vertical circuit off pin 2 of IC501 (LA7849). No print and writing on diode is so small, can't make it out. > > Please note - this circuit is different from the circuit in the DS27910 schematic. > > Thanks, > Wally Heise > South Isle Repair > Isle, Mn. > > -------------------------------------------------------------------------- --- > This Email List is accessible to the general public through search engines. Remove: http://www.tech-assist.org/remove.htm > Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation > Lost Password: http://www.tech-assist.org and select "Login Problems?". > Email Archives: //www.freelists.org/archives/techassist/ > > ----------------------------------------------------------------------------- This Email List is accessible to the general public through search engines. Remove: http://www.tech-assist.org/remove.htm Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/