yeah if that didn't work you will have to reinitialize the eeprom. Gary McCartney wrote: >Ralph, > >Thanks for the reply. As I stated in my original message, I did go into >the parental lock and made sure it was set to off, etc. >Any further ideas? > >Thanks. > > >Gary > > > >Ralph Dorsey wrote: > >>it's in the parental control (lock ) mode. Go into the main menu and you >>can set it to off some where in the menu. >> >>Gary McCartney wrote: >> >>>This is my first repair of CTC197 chassis. Set came in dead. Replaced >>>HOT, flyback and a couple resistors and soldered the tuner. Works fine >>>now. Only problem is that the menu button on the front panel does >>>nothing. All the other front panel buttons operate normally. >>> >>>I measured continuity of the menu switch when closed- is ok. Followed >>>the switch path through R117 to the micro IC and all traces are ok. The >>>menu button on the remote does work as normal. I went into the parental >>>control and made sure the front panel buttons were enabled. Then I >>>disabled them and then re-enabled them again. No difference. The TV >>>guide and PIP seem to be ok. >>> >>>Is this an eeprom problem? If so, can I correct it without a Chipper >>>Checker? I do have a regular eeprom programmer if someone knows what >>>byte would need to be reset or whatever. >>> >>> >>>One other question, I've read where there is an RCA bulletin to replace >>>a resistor and cap when flyback is changed. My flyback number is 237502. >>>It did not come with any bulletin regarding this. Does this mean my >>>version of the chassis is exempt from the alteration? >>> >>> >>>Thanks for any help. >>> >>------------------------------------------ >>Make your TechAssist database better! >>Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ >>------------------------------------------ >>To UNSUBSCRIBE your email address, click here: >>mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe >>Or send a BLANK email with unsubscribe in the >>SUBJECT field to the address above. >> > ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above.