Jerry check for the melted spacers on the board in the back, in the PIP module, and clean anywhere it has run. I am working on one that intermittently loses the video and I found that goop all over the place. This set was worked on by 3 other shops and so far I replaced the tuner which had the connectors badly soldered back on, fixed a broken trace on the left hand standup board, Replaced leaky caps and high ESR caps in vertical and power supply, PIP module and video board. Now I'm down to a crack or bad solder joint somewhere. These also cannot be run on a home made jig so you either bring the monster in or work at the home. Al Marquardt ampm@xxxxxxx Al Marquardt Electronic Repair 206 W Main Girardville Pa. 17935 ----- Original Message ----- From: "Gerald Gann" <alpha21century@xxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Thursday, August 05, 2004 7:28 PM Subject: [TechAssist] RCA PS35682 CTC170RA Need Schematic. No audio No video > RCA PS35682 CTC170RA Need Schematic. Has Hi voltage, No audio No video. > This is the first CTC170 I have seen. Dose that mean problems on these are rare? > This was made in 1994 and I only found one tip on the 170 chassis for different symptoms. > > Thanks > > > Jerry > > Alpha 21 Electronics > > Granite City, IL 62040 > > Ph. 618-452-8620 > > Fax 618-876-5157 > www.alpha21century@xxxxxxxxxxxxx > > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/