Bob, not sure what your saying, you want me to bridge R4104 with a 1.5 meg resistor? because pin 4 of the regulator is 0 volts? What is pin 4`s voltage supposed to be? Larry E Larry Eastman American TV & Electronics Crystal River, Fl. 34428 "Bob@Bobs tv" wrote: > Larry, > Bridge a 1.5m resistor (R4104) so you know for sure...Pin 4 needs a > + voltage to get the regulator going... > Bob, > > Bobs TV Worcester, ma > > woodman1@xxxxxxxx > > Main 508-853-1482 > Fax 508-853-1480 > ----- Original Message ----- > From: "Larry E" <videotech@xxxxxxxxxxxx> > To: <techassist@xxxxxxxxxxxxx> > Sent: Thursday, September 30, 2004 1:21 PM > Subject: [TechAssist] Re: RCA G35772AT CTC187CL DEAD/More info > > > Hi Guys, replaced the eprom and still have the same problem, zero volts on > pin 6, > > > > 4.32 on pin 8&5. Unsoldered pin 54 of U1001 thinking it might have been > pulling > > it down, no change, Q4105 is supposed to be the 5v standby source? (no > schematic) > > > > I have ( measured to cold ground) E= 4.77 B= 5.1 C= 11.7 volts. Could > the 4.32 > > > > be too low on pins 8 & 5 ? I was told pins 5&6 get the 5 volts from pin 8 > of > > U3201 > > so I`m still confused how pin 5 can have 4.32 but pin 6 would be zero if > the > > source > > is internally from pin 8 even with a new eprom installed, HELP!!! Larry > E > > > > Larry Eastman > > American TV & Electronics > > Crystal River, Fl. 34428 > > > > Larry E wrote: > > > > > Hi Guys, this 187CL is stone dead, no click from relay, HOT is good, > > > have 160 v on collector > > > in standby, resoldered H- driver transformer and the coil, C4107 is > > > good, found a bad > > > C4105 10uf @ 200 replaced it with no change, I need to know if the > > > voltages are correct > > > on U4101 as I don`t have the schematic, they are > > > Pin 1= -40 > > > 2= -33 > > > 4= 0 > > > 5= .9 > > > 6= .9 > > > 7= .4 > > > 8&9 = 0 > > > 11&12 = 165 thanks in advance, Larry E > > > Larry Eastman > > > American TV & Electronics > > > Crystal River, Fl. 34428 > > > > > > > -------------------------------------------------------------------------- > --- > > > Lost Password: > > > http://www.tech-assist.org and select "Login Problems?". > > > Email Archives: > > > //www.freelists.org/archives/techassist/ > > > > > > -------------------------------------------------------------------------- > --- > > Lost Password: > > http://www.tech-assist.org and select "Login Problems?". > > Email Archives: > > //www.freelists.org/archives/techassist/ > > > > ----------------------------------------------------------------------------- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/