B+ in standby will be 150 volts. run 140 volts.check it in standby,if high change C4123 R4125 in feedback.These parts will always check ok.If you have -40 volts on pin 1 the ic is usually ok. barrystv@xxxxxxx Barrys TV Ottawa Canada ----- Original Message ----- From: "David Lessard" <mr_fixit@xxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Thursday, May 13, 2004 2:17 PM Subject: [TechAssist] RCA CTC187 Chassis - Regulator Feedback Question > What resistors/capacitors could cause +B to rise to 150VDC? I thought +B > was 140VDC on this chassis. Could the extra 10VDC cause the HOT to fail > after 30 minutes? > > > Thanks in advance. > > > > David Lessard > > Alexandria Electronics > > 50 Harrison Street > > P.O. Box 1366 > > Alexandria, Ontario. > > Canada > > K0C-1A0 > > mr_fixit@xxxxxxxxxxxx > > > > > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/