If it ix the one with the splitter in the middle, you probably bumped the rings, been there,done that, what I do before I change splitter is to run a bead of hot glue on rings, saves a lot of work,hth. charles betzler Best Electronics repair1@xxxxxxxxxxxxx ----- Original Message ----- From: "al m" <ampm@xxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Sunday, March 09, 2003 10:21 AM Subject: [TechAssist] RCA CTC169 > This unit I replaced splitter and caps in power supply, took it back and the convergence was all out of whack. Convergence settings move very well but I couldn't get them to line up with the green.Customer said he had perfect picture when it went dead ( the usual comment ). So as the convergence controls were working I moved the rings on the tubes to converge the screen. My question is did I miss something or were the rings moved from the beginning? Looks good now. I set the convergence settings to center and lined them up with the green. > al marquardt > ampm@xxxxxxx > > > **************************************************************************** * > Submit A Repair Tip Here, or Change/Remove your Email Address: > http://www.tech-assist.org/secure/tip/main.html > **************************************************************************** * > For automatic password retrieval 24 hours a day, go to: > http://www.tech-assist.org and select "Lost your Login Info?". > **************************************************************************** * ***************************************************************************** Submit A Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.html ***************************************************************************** For automatic password retrieval 24 hours a day, go to: http://www.tech-assist.org and select "Lost your Login Info?". *****************************************************************************