It's usually bad solder at the coil LL04 on the base of the HOT, same as the CTC203 Robert tvservice@xxxxxxxxxxxxx H & H Electronics Inc http://supertek.igniteinc.biz ----- Original Message ----- From: "Gary Pahls" <bec@xxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Tuesday, October 25, 2005 11:02 AM Subject: [TechAssist] RCA ATC113CA1 Chassis - Blown H-Out Transistor > We have had 3, 32" RCA televisions come in this week, all with ATC113CA1 chassis and all with blown Horizontal Output transistors. After replacing the transistor and repairing a few suspicious looking solder connections the set works fine and the new transistor runs cool. Is there anything else we should look for causing these to blow or is it probably just the bad solder connections. > TIA > > Gary Pahls > Beloit Entertainment Center > bec@xxxxxxxxx > -------------------------------------------------------------------------- --- > This Email List is accessible to the general public through search engines. Remove: http://www.tech-assist.org/remove.htm > Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation > Lost Password: http://www.tech-assist.org and select "Login Problems?". > Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- This Email List is accessible to the general public through search engines. Remove: http://www.tech-assist.org/remove.htm Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/