John, It's a "Z" board. Check the pots on that board. Usually they change value because of the heat caused by that fat, hot resistor mounted under them. Dumb design. R754 is 5.6k/ 3wt on DP330 chassis. If not exactly what you have, should be close enough. That big resistor gets discolored, but rarely fails. Dominic DiLeo Atlantic TV Freeport, Maine ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ In a message dated 11/23/2005 7:09:07 PM Eastern Standard Time, maintv2004@xxxxxxxxxxx writes: I am wworking on a Quasar SP3231W, chassis ANEDC311 made in 1998. I repaired other problems and now have a good picture except that it is slightly pulled in on the right side of the screen. The B+ is 130v. I have checked the caps and resistors in the horiz circuit. The flyback rings good. This chassis has a small daughter board on the side of the chassis with width and PCC controls. Both controls change the picture but the width is out of range. Could someone send me the schematic of the horiz section and PCC board. Or let me know the value of R754, a 2 watt resistor on that PCC board. Everyone have a happy Thanksgiving. I won't be working on this again 'till after the holiday. John. John Mielke Main TV 636 Main St Longmont, Co 80501 303 776 6955 ----------------------------------------------------------------------------- This Email List is accessible to the general public through search engines. Remove: http://www.tech-assist.org/remove.htm Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/