I found this tip, Larry. Symptom: Set is in "PD Shutdown" and power supply appears to be defective but actually, only FU106 (4A, -25V) fuse is blown. After fuse is replaced, the set will work but the fuse filament can be seen to bend momentarily at power on. Cure: Problem is on Amp Assy. Resolder transistors and regulators that are mounted to the heat sink and replace one or both convergence output ICs (STK392-110). Models Covered: SDP50A3K, SDP50A3Q, SDP50A5K, SDP55A5K, SDP62A3K, SDP62A5 Tip Date: July 24 2000 Hope this is of some use to you. Tom Tom Sherman Bayside Electronics Digby, Nova Scotia Canada Phone/Fax: 902-245-5375 bayside.electronics@xxxxxxxxxxxxxxx larry wrote: >this set blows the fuse every 2 weeks, >no shorts, i tried a 1 amp higher , still does it. > >replace fuse works another few weeks, plays perfect between time. >any ideas??? >Thank you, >Larry > > > -- ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/