Ok on the half roll of solder, that was already done. Now if I could locate R266.......looked all over the power/deflection board and have not been able to spot it. Can you direct me to it? ******************************************************************************************************************* Since 1972 Jim Myers Telrad Electronics Fort Wayne, Indiana tony saracco wrote: > Check R266 for increase in reisitance, should be 160k, will probably read > around 200k and causes erratic shutdown. also dont forget to put half a roll > of solder on the board for good measure. > > Tony Saracco > TCS ELECTRONICS > 406 Andra Ct. > Gilberts, IL 60136 > tcselectronics@xxxxxxxxx > > ----- Original Message ----- > From: "Jim Myers" <jr.myers@xxxxxxxxxxx> > To: "TechAssist" <techassist@xxxxxxxxxxxxx> > Sent: Wednesday, March 03, 2004 9:15 AM > Subject: [TechAssist] Pioneer PTV SD-P5057, shuts down after 4-5 hours > > > No correct schematic on this but do have a close one. Any tips on this > problem. When it shuts down it must be unplugged and reconnected to > reset before it will power up again. > > ---------------------------------------------------------------------------- > - > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > > > > ----------------------------------------------------------------------------- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/