Larry Check the 10 ohm 1/2 watt on the crt board from the 200 volts R3340? Barry MacInnes Television Service Clinic W. Lebanon,NH 03784 foxhole@xxxxxxxxx 603-298-7780 ----- Original Message ----- From: "larry" <schntv@xxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Tuesday, August 10, 2004 10:10 AM Subject: [TechAssist] Re: Phillips 25B800 , shut down, need schematic > the cap looks ok, but another thing, the current is very low, > and it seems that only a little lite on the screen causes shut > down. > Thank you, > Larry > > > Intrepid Video Support wrote: > > Larry, > > Check for a shorted disk cap next to HOT...probably leaning against the heat sink. > > Jeff > > -- > > Intrepid Video TV/VCR Repair > > 263 S Front St, Steelton PA 17113 > > 717-939-7708; (F) 717-564-4952 > > www.intrepid-video.com www.tech-repair.net > > ----- Original Message ----- > > From: "larry" <schntv@xxxxxxxxxxxx> > > To: <techassist@xxxxxxxxxxxxx> > > Sent: Monday, August 09, 2004 4:38 PM > > Subject: [TechAssist] Phillips 25B800 , shut down, need schematic > > > > > > phillips 25b800, had no vertical, > > I cant seem to find a schematic of the crt board for this chassis. > > replaced vert ic, > > rectifier, resistor, 2 electrolytics. > > comes on for 4 seconds then shutdown. > > too much screen drive. > > white with retrace. > > adjusting screen control is very sensitive. > > can a shorted vert. cause video damage? > > Thank you, > > Larry > > > > -- > Schneider TV & Electronic Inc. > 5415 N. Wooster ave. > Dover, Ohio 44622 www.geocities.com/schntv2000/ > 330-343-0768 FCC. first class & Extra class K8WLY > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/