1 5 volts 2 Gnd 3 Pg 4 12 volts 5 Fg 6 Gnd 7 Control. Control is 2.7 volts drum running. Probably 3 to 4 volts to get it started. 3erry Silverman Greentron Inc 4 Newland Ave Greenville SC 29609 864 232 3889 Fax 271 2080 mailto:greentron@xxxxxxx ----- Original Message ----- From: "breadywater" <breadywater@xxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Monday, September 09, 2002 10:35 PM Subject: [TechAssist] Phillip combo modell CCC190AT31 > Phillip model CCC190AT31 > On this combo unite I have the following problem when I put the tape in evrithing work ok. but the video head do not move at all. I check the voltage at the ribbon cable that go to the head stator and see I have voltage there but I do not know if this is the right voltage that is suppose to be there. > Do someone have any diagram and can scan the power supply section and the head voltages me please? > Also I would like to know the price of the video head and where can I get it. > thank you in advance. > Jose R. Paniagua > Paniagua TV/VCR service > breadywater@xxxxxxx > > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ > ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/