[TechAssist] Re: Philips SSC192 TV/VCR need info
- From: "Jerome Silverman" <greentron@xxxxxxx>
- To: <techassist@xxxxxxxxxxxxx>
- Date: Sun, 3 Jul 2005 19:25:18 -0400
What is the model year?
Jerry Silverman
Greentron Inc
4 Newland Ave Greenville SC 29609
Fax/Phone 864 232 3889
greentron@xxxxxxx
----- Original Message -----
From: "al m" <ampm@xxxxxxx>
To: <techassist@xxxxxxxxxxxxx>
Sent: Sunday, July 03, 2005 1:46 PM
Subject: [TechAssist] Re: Philips SSC192 TV/VCR need info
> Yes the TV part works. The power supply is all there ( I think) but the
> Signal coming out of the Micro to the motor seems to be missing. The
Sensor
> voltage is getting to the micro, so if it is the sensor signal that turns
on
> the motor then I have a bad Micro I guess. I think Pin 82 is the load
> carriage pin and nothing happening there. Thanks for the response.
> Al Marquardt
> ampm@xxxxxxx
> Al Marquardt Electronic Repair
> 206 W Main
> Girardville Pa. 17935
> ----- Original Message -----
> From: <tjanphyl@xxxxxxxxxxxxxxx>
> To: <techassist@xxxxxxxxxxxxx>
> Sent: Sunday, July 03, 2005 1:41 PM
> Subject: [TechAssist] Re: Philips SSC192 TV/VCR need info
>
>
> > I/R sensors are common with these, and any regulators with the "KIA"
> > prefix suspect. Any KIA7805, KIA7806, etc. You replaced the HOT- do I
> > understand the TV part now works OK?
> > Maybe the customer was using it as just a TV when that failed. Maybe
> > the deck and the HOT issue are unrelated and failed at different times.
> > Some of these use small square pico type fuses around the SMPS. Check
> > and components like that for opens.
> > Phil Bader
> >
> > ----- Original Message -----
> > From: al m <ampm@xxxxxxx>
> > Date: Sunday, July 3, 2005 1:35 pm
> > Subject: [TechAssist] Philips SSC192 TV/VCR need info
> >
> >> Hope everyone is enjoying the Holidays. This unit won't accept a
> >> tape. Does
> >> the Start LED tell the micro to run the Motor? It looks like it
> >> does. LED is
> >> working but nothing coming out of the Micro to turn the motor on.
> >> Tested
> >> motor and it works. I think that blocking the start sensor should
> >> turn the
> >> motor on to the load the carriage, am I right on this? I have a
> >> print.
> >> Replaced Mode switch. Oh the unit had a shorted HOT when I got it
> >> the power
> >> supply was squealing. I have tried it in the case to make sure the
> >> light was
> >> not screwing with it. Thanks.
> >> Al Marquardt
> >> ampm@xxxxxxx
> >> Al Marquardt Electronic Repair
> >> 206 W Main
> >> Girardville Pa. 17935
> >>
> >>
> >> -------------------------------------------------------------------
> >> ----------
> >> This Email List is Public. Remove: http://www.tech-
> >> assist.org/remove.htmSet Vacation
> >> mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacationLost
> > Password: http://www.tech-assist.org and select "Login Problems?".
> >> Email Archives: //www.freelists.org/archives/techassist/
> >>
>
> --------------------------------------------------------------------------
---
> > This Email List is Public. Remove: http://www.tech-assist.org/remove.htm
> > Set Vacation
> > mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation
> > Lost Password: http://www.tech-assist.org and select "Login Problems?".
> > Email Archives: //www.freelists.org/archives/techassist/
> >
> >
>
>
> --------------------------------------------------------------------------
---
> This Email List is Public. Remove: http://www.tech-assist.org/remove.htm
> Set Vacation
mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation
> Lost Password: http://www.tech-assist.org and select "Login Problems?".
> Email Archives: //www.freelists.org/archives/techassist/
-----------------------------------------------------------------------------
This Email List is Public. Remove: http://www.tech-assist.org/remove.htm
Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation
Lost Password: http://www.tech-assist.org and select "Login Problems?".
Email Archives: //www.freelists.org/archives/techassist/
Other related posts:
