Don't have a print but does it have a small stand-by power transformer ( cap & diode) off the AC input to provide 5 and 12 volt stand-by voltages? Country TV Ron Miller Inez, TX. 77968 ----- Original Message ----- From: "Bruce Tiedeman" <btied@xxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Sunday, August 22, 2004 9:48 AM Subject: [TechAssist] Panasonic PC-33X78S(Yanedp212) No Start condition! > I am hoping some has a print of the power supply on this set. There is no > relay activity when power is applied. If I jumper the relay the set starts > up with a blue screen. I have no 12 volts present on the primary side of the > relay. > This set uses a STRS6301 regulator. The power supply is on a separate board > from the main chassis. I have checked all the caps and diodes in the power > supply. When the set starts up the waveform looks clean and is vary stable > at 135 volts so the regulator seems ok? > thanks for any help, > Bruce. > > B&T Electronics > 139 Margaret St > Sarnia Ontario > Canada > N7T 2Y3 > 519 344 1850 > > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/