Thanks Jim; I got the Manual from Bob Waterman. I only have about 6.5 Volts at my 12 Volt line. Something is drawing it down. If I lift the lead from my supply cap, it goes up to 12 volts. Tried jumpering the relay, but no HV. Various supplies are tapped off of the 12 Volt line, and 5 Volts is one, so I suspect bad micro, but not sure. -Ed- Tel-Tek Electronics teltek3@xxxxxxxxxxxx Ontario-Canada -----Original Message----- From: techassist-bounce@xxxxxxxxxxxxx [mailto:techassist-bounce@xxxxxxxxxxxxx] On Behalf Of Jim Myers Sent: Wednesday, August 11, 2004 4:19 PM To: techassist@xxxxxxxxxxxxx Subject: [TechAssist] Re: Panasonic CT27G5CB Chassis-GP325 (Man 2000) Ed, I have a paper manual. Do you have standby voltage at the relay coil? Does the base of relay driver Q001 show any change when the power switch is pressed? Can you jumper the relay contact pins and get HV? ************************************************************************ ******************************************* Since 1972 Jim Myers Telrad Electronics Fort Wayne, Indiana Tel-Tek Electronics wrote: > I presume this set had a trickle of lightning. Fuse is not > blown, can find no shorts. No Relay click. Just Dead. > I have no Manual on this...anyone have any tips and/or Manual? > > TIA > > -Ed- > > Tel-Tek Electronics > teltek3@xxxxxxxxxxxx > Ontario-Canada > > > > ------------------------------------------------------------------------ ----- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > ------------------------------------------------------------------------ ----- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/