Are you saying in #3 that the er, uh ....Mute (1) (#) (*) will not bring up the conv grid anymore? Don't want the code available to the public, so you know what I mean, right? If the grid don't come up, it is possible that the DCU got a hit of HV...but I think I'd verify b+ to the conv ic, and since the conv board is separate, you can check the incoming Conv signal is present on the connector at the Conv output board.....that is a + on this unit. I don't know if I can ship schematics, but if you need them, I'll give it a shot...the schematics can be 10 to 20 meg, and my mailbox seems to cut a 20 meg short by 1 or 2 meg...won't ship it if it's over that amount. So we'd have to find a place to transfer that PDF file....as a whole.... The good thing is Samsung breaks down their manuals into 5 meg sections, or less.....I'd have to mail a piece at a time and send the next one after you recieved the first one possibly I might try to send directly to you after I finish this..... Damon B Telrad Electronics Fort Wayne IN ----- Original Message ----- From: "GERALD GANN" <alpha21century1234@xxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Wednesday, December 14, 2005 10:53 AM Subject: [TechAssist] Re: One more try Samsung PCH521R May need schematic. Convergence problem. > Thanks Damon for the input. Life is great, a lot better than the > > alternatives. > > 1. All inputs did adjusted fine and saved. I had turned the > > TV off and back to make sure. > > 2. TV doesn't have Flash focus. > > 3. I can't even get the customers convergence to move, same > > as before I started working on it. Also can't get into > > convergence setup grids same as before. Thanks again. > > Jerry > > > Damon <DamonEB@xxxxxxxxxxx> wrote: Well Damn Jerry....your life sucks! Doesn't it..... > Anyways, there's several things to consider. [1] Did Samsung make the > convergence adjustable for EACH input?? > (Been there, done that). > [2] Did you SAVE and FORGET to Flash focus (if it has it)? You'll lose your > new settings everytime on Samsung/Sony/Hitachi..... > 3] and most important...can you still ADJUST the convergence grids? If so, > you probably wiped the Eeprom's contents. > On 1 2 and 3 you need to adjust the convergence, if it doesn't move at all, > well....I'm sure you've checked that already. Do you need an Eeprom > replace?? I really don't think so, you'll know it if you SAVE one or 2 > points, turn off the TV, back on, and those points have gone back to their > first setting.... > > Damon B > Telrad Electronics > Fort Wayne IN > ----- Original Message ----- > From: "GERALD GANN" > To: > Sent: Tuesday, December 13, 2005 3:58 PM > Subject: [TechAssist] Re: One more try Samsung PCH521R May need schematic. > Convergence problem. > > > > PCH521R is definitely different than the PCJ522R. The convergence and > the audio board are together and stand up on the left side looking from the > back. I can download the PCH521R from ServiceManuals.net but I thought I > would check one more time on the list before I spend the $24.00. > > OK Here's the lowdown. After changing all there STK's and the 3A > fuse in the P/S as stated in T/A tip. I set up the convergence to perfection > and saved. After doing that I noticed I only had audio coming from one > speaker. Being convergence and audio are on the same board I reached inside > from the front to flex the board, I only assume I did this so I could hear > if the other speaker came on. Anyway whammm it got me. That hurts. I don't > know where the high voltage came from but it burned a pin hole in my middle > finger and a small mark on my pointer finger when I touched the audio IC > heat sink. You can call me dummy I know I should have used a wooden stick. I > could be wrong but my guess would be it has happened to all of us at some > time or another. > > Anyway after that I pulled the convergence/audio board and > resoldered the audio circuit audio came back on both sides but convergence > was back to the way it was before I started. Question could the high voltage > zap have taken out the 3 STK's or do need to go to the power supply? I > checked all the fuses on the power supply board and they are good. I do need > the schematic for the PCH521R > > Sorry for the long post but I thought it necessary to tell all to > get a good response. Thanks. > > Jerry > > Alpha 21 Electronics > > Granite City, IL 62040 > > 618-452-8620 > > alpha21century1234@xxxxxxxxxxxxx > > > > GERALD GANN wrote: Thanks Bill that's > why I ask I have the PCJ522R. > > > > The convergences board is definitely different. As long as the > > > > procedure or the same I can go from there. I did a PCJ522R > > > > awhile back and had to order a special remote to save changes. > > > > Thanks again. > > > > Jerry > > Alpha 21 Electronics > > Granite City, IL 62040 > > 618-452-8620 > > alpha21century1234@xxxxxxxxxxxxx > > > > > > Premium Technologies > > wrote: Gerald, > > Almost identical, both are the same chassis, and the PCJ522R is on file in > the members > > area... If you have any problems getting it I have it and I'd be glad to > download it or > > sections of it that you need... > > Bill > > > > William Rayburn, CET > > Premium Technologies > > PO Box 442 > > Long Beach, WA. 98631 > > 360-642-4993 > > > > ----- Original Message ----- > > From: "GERALD GANN" > > To: > > Sent: Tuesday, December 06, 2005 12:33 PM > > Subject: [TechAssist] Re: OK new question. Samsung PCH521R May need > schematic. Convergence > > problem. > > > > > > OK new question. Being I got no replay on my first post. Can > > > > some tell me if the convergence setup is the same for this modal > > > > as it is for the PCJ522R? The schematic would still be great. > > > > Thanks. > > > > Jerry > > Alpha 21 Electronics > > Granite City, IL 62040 > > 618-452-8620 > > alpha21century1234@xxxxxxxxxxxxx > > > > > > GERALD GANN wrote: > > Samsung PCH521R May need schematic. Convergence problem. > > > > Found this tip in T/A > > > > Garris TV, Make: Samsung, Model: PCH521R, Chassis > > > > APT51B, > > > > Problem: Convergence way off and unable to adjust, top/bottom bowed-in., > > Cure: Open 3A on P/S Module located on right side of chassis, this fuse > protects the -26v > > going to all (3) STK391-020 Convergence IC's which are located on left > side of chassis on > > large heat-sink. Replaced 3A fuse on SMPS board and replaced all (3) > STK391-020 Convergence > > IC's on the Convergence/Sound board. > > Comments > > > > > > Before I change all three STK's, looks like a > > > > pain in the axx's. Anyone have any quick fixes? No leakage from > > > > tubes. > > > > Jerry > > Alpha 21 Electronics > > Granite City, IL 62040 > > 618-452-8620 > > alpha21century1234@xxxxxxxxxxxxx > > > > > > > > > > > > -------------------------------------------------------------------------- > --- > > This Email List is accessible to the general public through search > engines. Remove: > > http://www.tech-assist.org/remove.htm > > Set Vacation > mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation > > Lost Password: http://www.tech-assist.org and select "Login Problems?". > > Email Archives: //www.freelists.org/archives/techassist/ > > > > > > -- > > No virus found in this incoming message. > > Checked by AVG Free Edition. > > Version: 7.1.371 / Virus Database: 267.13.12/192 - Release Date: 12/5/2005 > > > > > > -------------------------------------------------------------------------- > --- > > This Email List is accessible to the general public through search > engines. Remove: http://www.tech-assist.org/remove.htm > > Set Vacation > mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation > > Lost Password: http://www.tech-assist.org and select "Login Problems?". > > Email Archives: //www.freelists.org/archives/techassist/ > > > > > > > > > > -------------------------------------------------------------------------- > --- > > This Email List is accessible to the general public through search > engines. Remove: http://www.tech-assist.org/remove.htm > > Set Vacation > mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation > > Lost Password: http://www.tech-assist.org and select "Login Problems?". > > Email Archives: //www.freelists.org/archives/techassist/ > > > > > > > > > > -------------------------------------------------------------------------- > --- > > This Email List is accessible to the general public through search > engines. Remove: http://www.tech-assist.org/remove.htm > > Set Vacation > mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation > > Lost Password: http://www.tech-assist.org and select "Login Problems?". > > Email Archives: //www.freelists.org/archives/techassist/ > > > > > -------------------------------------------------------------------------- --- > This Email List is accessible to the general public through search engines. Remove: http://www.tech-assist.org/remove.htm > Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation > Lost Password: http://www.tech-assist.org and select "Login Problems?". > Email Archives: //www.freelists.org/archives/techassist/ > > > > > -------------------------------------------------------------------------- --- > This Email List is accessible to the general public through search engines. Remove: http://www.tech-assist.org/remove.htm > Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation > Lost Password: http://www.tech-assist.org and select "Login Problems?". > Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- This Email List is accessible to the general public through search engines. Remove: http://www.tech-assist.org/remove.htm Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/