I worked on one of those awhile ago and it turned out to be two caps near the back of the chassis if I remember right they are 47 uf 50 or 100 volt. hth Shaun Advanced Electronics Fort Morgan, CO 80701 (970) 867-3124 satguy@xxxxxxxxxxxxx ----- Original Message ----- From: <Ttkirkpat@xxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Thursday, December 05, 2002 10:09 PM Subject: [TechAssist] Mitsubishi model CK-3530R- black lines in picture > Here we go, set works fine at turn on. After 10 minutes the video will > develop black streaks along the edges of people,etc.. It seems to increase > the longer it is on. There is nothing loose, freeze does not affect it. I > replaced 10 filters in the video and power supply circuits because of > leakage. None of these made a difference. I feel confident that I am > overlooking a filter or cap leaking but ran out of daylight. If by some > miracle of the imagination someone has seen this , make my day by sharing > your knowledge. Thanks from Mike at the Video Center. My e-mail is > ttkirkpat@xxxxxxx > > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/