The PIP module may be at fault. Remove it & install the parts on the bottom of the board to verify. "Vp" Plug From Pip Mod.Install .01 From Pin 7 To Pin 9 Install 4.7/35-50v;Pos.To Pin 5,Neg. To Pin 11 If your problem is then resolved....you can elect to repair the PIP board or if the customer NEVER uses it...leave it bypassed. Jeff Stielau Shoreline Electronics Repair 125 Beechtree Lane Westbrook,CT 06498 860-399-1861 Voice 860-664-3535 Fax jstielau@xxxxxxxx ----- Original Message ----- From: "preston McGiboney" <pmcgiboney@xxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Friday, November 02, 2001 1:52 PM Subject: [TechAssist] Mitsubishi CS 27401 > > Tv will come on normally. After short time will show > wavy lines mainly at upper portion of screen. Also, > when changing channels station will come in at first > then sometimes will drift off. If you switch cannels > then back it usually comes on and stays. Any help out > there? > > Thanks, Preston > > > > > > __________________________________________________ > Do You Yahoo!? > Find a job, post your resume. > http://careers.yahoo.com > Help make your TechAssist online repair tips > database better! Submit your fixes here: > http://www.circuitwork.com/techassist/tip/#tips > To unsubscribe write to: > techassist-request@xxxxxxxxxxxxx > with unsubscribe in the subject line. > Help make your TechAssist online repair tips database better! Submit your fixes here: http://www.circuitwork.com/techassist/tip/#tips To unsubscribe write to: techassist-request@xxxxxxxxxxxxx with unsubscribe in the subject line.