I forgot to mention to specifically check resistor R61 on the CRT board. This is a common failure (220K, 1/4 watt). Replace it with a 1/2 watt. Bob Waterman, CET® #RI-28 Master Technician License #9109 Service Manager Gemini Computer, TV, & Security Alarms (508)695-7302 (508)695-7769 FAX geminitv@xxxxxxxxxxxxxxxx geminitv@xxxxxxx ----- Original Message ----- From: "Gemini Computer & TV" <geminitv@xxxxxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Thursday, December 26, 2002 10:13 AM Subject: [TechAssist] Re: Magnvox, 27TP83, ch. 27v505, no video > > First, > Give us the voltage readings on all 9 pins of IC51 on the CRT board. Pins > 1,2, and 3 are the R,G, and B inputs respectively (pins 7,8, and 9 are the > outputs). Also scope the inputs to see if you have video coming in. If not > then the video comes from IC200 (pins 21, 20, and 19 are R,G,B > respectively). This should get you started. > > Bob Waterman, CET® #RI-28 > Master Technician License #9109 > Service Manager > Gemini Computer, TV, & Security Alarms > (508)695-7302 > (508)695-7769 FAX > geminitv@xxxxxxxxxxxxxxxx > geminitv@xxxxxxx > > ----- Original Message ----- > From: "D Thunhurst" <dthunhurst@xxxxxxx> > To: "TechAssist" <TechAssist@xxxxxxxxxxxxx> > Sent: Thursday, December 26, 2002 9:05 AM > Subject: [TechAssist] Magnvox, 27TP83, ch. 27v505, no video > > > > > > Good morning. > > I hope everyone had a merry Christmas. > > I am still having some problems with this set. Originally it came in with > > sound and no vert. deflection, in on both sides about 3 inches and would > > shut down after a few seconds. > > I replaced R464 (went high in value), IC401 (9 volt reg), and IC550 (vert. > > output). Now, I still have sound, full deflection both vertically and > > horizontally, bright raster with full retrace lines and no video. I have > > the 200 volts to the crt board and all of the resistors check ok on that > > board. I could use a little advice on this one as I don't have the > > schematic and Sams doesn't list anything one it. Tritronics list a manual > > for it but at $60 plus shipping is out of the question. I am leaning > > towards jungle chip but not sure as this is a guess. > > Thanks, > > Daryl > > Daryl's TV > > 3310 Dyer St. > > El Paso, TX 79930 > > 915-565-9184 > > 915-564-1024 Fax > > http://dynacomp.freeyellow.com > > > > ------------------------------------------ > > Submit A Repair Tip For Everyone Here: > > http://www.tech-assist.org/secure/tip/main.html > > ------------------------------------------ > > To REMOVE your email address, click here: > > http://www.tech-assist.org/unsubb.html > > To CHANGE your email address, click here: > > http://www.techassist.net/forms/change.html > > > > > > ------------------------------------------ > Submit A Repair Tip For Everyone Here: > http://www.tech-assist.org/secure/tip/main.html > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > > ------------------------------------------ Submit A Repair Tip For Everyone Here: http://www.tech-assist.org/secure/tip/main.html ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html