Some of the 3 disc changers have IR sensors that tell what discs are in place. Check for loose connections to IR sensors. I've had this happen on a few RCA units where you put a disc in and its exhibiting your same symptom you're having with this JVC. Maybe they're made by the same company. Further advice awaits if needed. Joe Svatek Owner Svatek's Electronics 227 Marten St. Neenah,WI 54956-2520 Phone: (920) 751-8937 Fax : (920) 751-3727 email: Svatek227@xxxxxxx In a message dated 7/28/2003 12:37:36 PM Central Daylight Time, shannen@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx writes: > I am working on one of these newer changer units. I have a few of these > with similar symptoms but have not been able to figure them out yet. The > mechanism seems to lose disc memory intermittenly. You can load the unit > with 3 discs, and after shuttling between them the unit will say no disc in > the tray when there actually is. Are there any service bulletins or common > problems with these newer mechanisms. Thanks in advance. Shannen > > Shannen's Electronics > 1619 N Taylor Ave. > Garden City, KS 67846 > (620) 275-4660 > (620) 275-4668 (fax) > shannen@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx > > > ***************************************************************************** Classifieds! Buy or Sell! http://sell.tech-assist.org The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/