Mike, Yes...supporting supply voltages are fine. This unit uses several of these IC's. I was able to swap a couple around to verify fault. Thanks for your input! Jeff Stielau Shoreline Electronics Repair 125 Beechtree Lane Westbrook,CT 06498 860-399-1861 Voice 860-664-3535 Fax jstielau@xxxxxxxx ----- Original Message ----- From: <jmgoins.tn@xxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Wednesday, October 03, 2001 12:53 AM Subject: [TechAssist] Re: IC Needed : TL604 8 pin DIP > I do not have the chip, but I thought of something I should mention. I did > a search for this when you posted it, and I think it was described as a > PMOS part. It has been a long time since I have seen any PMOS, but as I > recall cautions regarding the -5v substrate supply (Rams were the only PMOS > parts I really remember using). This may not apply here at all, but before > you install the new chip, if the chip uses a minus supply, be CERTAIN that > it is functional. > > Mike Goins jmgoins.tn@xxxxxxxxxxx > > At 11:31 AM 9/26/01 -0400, you wrote: > > > > > >Does anyone have any TL604 ic's in their stock. > > > >Used in Peavey & Gallien Krueger amps....old part. Hard to find. Peavey has > >little circuit board & IC that replaces it....expensive! > > > >Jeff Stielau > >Shoreline Electronics Repair > >125 Beechtree Lane > >Westbrook,CT 06498 > >860-399-1861 Voice > >860-664-3535 Fax > >jstielau@xxxxxxxx > > > > > >Help make your TechAssist online repair tips > >database better! Submit your fixes here: > >http://www.circuitwork.com/techassist/tip/#tips > >To unsubscribe write to: > >techassist-request@xxxxxxxxxxxxx > >with unsubscribe in the subject line. > > > > > > > >--- > >Incoming mail is certified Virus Free. > >Checked by AVG anti-virus system (http://www.grisoft.com). > >Version: 6.0.281 / Virus Database: 149 - Release Date: 9/18/01 > > > > > > Help make your TechAssist online repair tips > database better! Submit your fixes here: > http://www.circuitwork.com/techassist/tip/#tips > To unsubscribe write to: > techassist-request@xxxxxxxxxxxxx > with unsubscribe in the subject line. > Help make your TechAssist online repair tips database better! Submit your fixes here: http://www.circuitwork.com/techassist/tip/#tips To unsubscribe write to: techassist-request@xxxxxxxxxxxxx with unsubscribe in the subject line.