Also try to replace c161,c162,c164, check r427 (180k) Good luck Frank --- Frank Luu <fkluu@xxxxxxxxx> wrote: > > > sorry to say but ic z200 (micro/eprom) need to > reprogram. > Frank > --- Sam Faber <sfaber@xxxxxxxxxx> wrote: > > Hi People, > > > > I Have an IBM G50 (6543304) monitor, it cuts out > > when the brightness is turned up or when it > switches > > to a different resolution. It needs to be switched > > off for a few seconds and on again to reset the > > picture. > > > > There are also two yellow shadows across the > screen > > when the brightness is increased. > > > > I have managed to get a schematic for the G50 > > (6543301), from http://rv6llh.rsuh.ru/G50.pdf > > > > Regards Sam Faber VK2GLN > > > > > > ***************************************** > > Help make your TechAssist online repair tips > > database better! Submit your fixes here: > > http://www.circuitwork.com/techassist/tip/#tips > > ***************************************** > > To UNSUBSCRIBE write to: > > techassist-request@xxxxxxxxxxxxx > > with unsubscribe in the subject line. > > > __________________________________________________ > Do You Yahoo!? > Find a job, post your resume. > http://careers.yahoo.com > ***************************************** > Help make your TechAssist online repair tips > database better! Submit your fixes here: > http://www.circuitwork.com/techassist/tip/#tips > ***************************************** > To UNSUBSCRIBE write to: > techassist-request@xxxxxxxxxxxxx > with unsubscribe in the subject line. __________________________________________________ Do You Yahoo!? Find a job, post your resume. http://careers.yahoo.com ***************************************** Help make your TechAssist online repair tips database better! Submit your fixes here: http://www.circuitwork.com/techassist/tip/#tips ***************************************** To UNSUBSCRIBE write to: techassist-request@xxxxxxxxxxxxx with unsubscribe in the subject line.