EEPROM is 224281. If you need one I have some pre-programmed. Max Bonnell Bonnell TV Robinson, IL Sender: techassist-bounce@xxxxxxxxxxxxx From: llw@xxxxxxxxxx(LeRoy=A0Westlund) Date: Thu, Nov 25, 2004, 9:44am (CST-1) To: techassist@xxxxxxxxxxxxx Subject: [TechAssist] Re: GE 27GT615 CTC177BH2 in HV shutdown Reply=A0to: techassist@xxxxxxxxxxxxx Always try another EPROM when you have unsolvable shutdown problems on the CTCxxx chassis. Install an 8-pin socket to save on trace damage. It may be that the horz freq. is simply too far off. This will cause the high voltage to rise, and the set will shut down. HTH, LLW LeRoy Westlund Westlund TV & Electronics 97 North Main =A0 =A0 =A0 =A0 =A0 =A0 =A0 =A0 =A0 =A0 =A0 =A0 =A0 =A0 " I forgot,..to remember,.. Centerfield, UT 84622-0087 =A0 =A0 =A0 =A0 =A0 to forget " Ph./Fax 435-528-3822 mailto:LLW@xxxxxxxxxx -----Original Message----- From: Peter oliver <oliver_peter1@xxxxxxxxxxx> To: techassist@xxxxxxxxxxxxx <techassist@xxxxxxxxxxxxx> Date: Wednesday, November 24, 2004 5:50 PM Subject: [TechAssist] GE 27GT615 CTC177BH2 in HV shutdown GE 27GT615 CTC177BH2 =A0=A0=A0=A0=A0=A0=A0=A0=A0=A0=A0=A0=A0=A0=A0=A0=A0=A0=A0=A0=A0=A0=A0=A0=A0= =A0=A0=A0Appears to be in an odd HV shutdown???---Push power clicks a high pitch momentary squeel then cycles. On my Sencore VA62 the flyback gives 41-45 rings. B+ appears to be high at about 174v Have checked a number of caps in the horz section and tested diodes also. The set will run with a vertical line if the horizontal yoke plug is pulled (it rings 25x) Peter Oliver Tucson Radio TV ---------------------------------------------- -- ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/