Heh, glad I'm not the only one...... Damon Brunger damon101@xxxxxxxxxxxxxx Telrad Electronic Services Ft Wayne, IN 46815 ----- Original Message ----- From: "Phil Bader" <philbad@xxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Friday, October 05, 2001 10:48 AM Subject: [TechAssist] Re: [Fwd: RCA F25216WT, CTC185AB dead,bad HOT,regulator,open R103U.] > > Dar-Heeeeee I was having a senior moment,guys...I know this stuff! > > Jim Myers wrote: > > > > Easy to figure out Phil, just use ohm meter to locate the other primary > > pin(s). There should be no ohms reading to any secondary pin, then connect > > ringer leads across the primary. Flyback is out of circuit, right? > > Jim Myers > > jr.myers@xxxxxxxxxxx > > ----- Original Message ----- > > From: "Phil Bader" <philbad@xxxxxxxxxx> > > To: <techassist@xxxxxxxxxxxxx> > > Sent: Friday, October 05, 2001 8:36 AM > > Subject: [TechAssist] [Fwd: RCA F25216WT, CTC185AB dead,bad > > HOT,regulator,open R103U.] > > > > > > > > > > > > > > -------- Original Message -------- > > > Subject: RCA F25216WT, CTC185AB dead,bad HOT,regulator,open R103U. > > > Date: Fri, 05 Oct 2001 09:19:13 -0400 > > > From: Phil Bader <philbad@xxxxxxxxxx> > > > Organization: Jan Phyl TV Inc. Winter Haven, Fl. Estab. 1976 > > > To: "CONSUMERELREPAIR-L@xxxxxxxxxxxxxxxxxxxx" > > > <CONSUMERELREPAIR-L@xxxxxxxxxxxxxxxxxxxx> > > > > > > Question: Before I install the reg kit 231523,HOT,resistor,I rang the > > > fly and get "BAD"but want to verify the correct fly pins to ring. One > > > lead on the HOT collector fly pin ( I assume),and where goes the other > > > ringer lead? (no schemo).Plse use component reference for > > > location.Thx,Phil > > > Help make your TechAssist online repair tips > > > database better! Submit your fixes here: > > > http://www.circuitwork.com/techassist/tip/#tips > > > To unsubscribe write to: > > > techassist-request@xxxxxxxxxxxxx > > > with unsubscribe in the subject line. > > > > Help make your TechAssist online repair tips > > database better! Submit your fixes here: > > http://www.circuitwork.com/techassist/tip/#tips > > To unsubscribe write to: > > techassist-request@xxxxxxxxxxxxx > > with unsubscribe in the subject line. > Help make your TechAssist online repair tips > database better! Submit your fixes here: > http://www.circuitwork.com/techassist/tip/#tips > To unsubscribe write to: > techassist-request@xxxxxxxxxxxxx > with unsubscribe in the subject line. > Help make your TechAssist online repair tips database better! Submit your fixes here: http://www.circuitwork.com/techassist/tip/#tips To unsubscribe write to: techassist-request@xxxxxxxxxxxxx with unsubscribe in the subject line.