Dar-Heeeeee I was having a senior moment,guys...I know this stuff! Jim Myers wrote: > > Easy to figure out Phil, just use ohm meter to locate the other primary > pin(s). There should be no ohms reading to any secondary pin, then connect > ringer leads across the primary. Flyback is out of circuit, right? > Jim Myers > jr.myers@xxxxxxxxxxx > ----- Original Message ----- > From: "Phil Bader" <philbad@xxxxxxxxxx> > To: <techassist@xxxxxxxxxxxxx> > Sent: Friday, October 05, 2001 8:36 AM > Subject: [TechAssist] [Fwd: RCA F25216WT, CTC185AB dead,bad > HOT,regulator,open R103U.] > > > > > > > > > -------- Original Message -------- > > Subject: RCA F25216WT, CTC185AB dead,bad HOT,regulator,open R103U. > > Date: Fri, 05 Oct 2001 09:19:13 -0400 > > From: Phil Bader <philbad@xxxxxxxxxx> > > Organization: Jan Phyl TV Inc. Winter Haven, Fl. Estab. 1976 > > To: "CONSUMERELREPAIR-L@xxxxxxxxxxxxxxxxxxxx" > > <CONSUMERELREPAIR-L@xxxxxxxxxxxxxxxxxxxx> > > > > Question: Before I install the reg kit 231523,HOT,resistor,I rang the > > fly and get "BAD"but want to verify the correct fly pins to ring. One > > lead on the HOT collector fly pin ( I assume),and where goes the other > > ringer lead? (no schemo).Plse use component reference for > > location.Thx,Phil > > Help make your TechAssist online repair tips > > database better! Submit your fixes here: > > http://www.circuitwork.com/techassist/tip/#tips > > To unsubscribe write to: > > techassist-request@xxxxxxxxxxxxx > > with unsubscribe in the subject line. > > Help make your TechAssist online repair tips > database better! Submit your fixes here: > http://www.circuitwork.com/techassist/tip/#tips > To unsubscribe write to: > techassist-request@xxxxxxxxxxxxx > with unsubscribe in the subject line. Help make your TechAssist online repair tips database better! Submit your fixes here: http://www.circuitwork.com/techassist/tip/#tips To unsubscribe write to: techassist-request@xxxxxxxxxxxxx with unsubscribe in the subject line.