Do the tuner & micro grounds. If that doesn't fix it, try changing the switches on the front panel. Good Luck, John Myers Myers TV Service Since 1984 Alliance, OH ph 330-821-6545 myers_tv@xxxxxxxxxxxxx www.alliancetvrepair.com ----- Original Message ----- From: "S. Pasher" <spasher@xxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Tuesday, August 17, 2004 9:58 PM Subject: [TechAssist] CTC-187CL3 WithON/OFF etc. on seperate board > Set brought in no power. Replaced F/B and H/O , ran set for 6 hours on > bench. Customer picked up on Thursday. He returned with it on Monday. It is > some times interment and won't start. When it does start it will run for > 15-20 mins OK , then it will start to change channels every 1 or 2 secs, you > also lose any control from the buttons (ON/OFF) etc. There is a connector > that connects the front panel control board to the main chassis. If you pull > the connector from the main chassis it will stop changing channels and will > stay on the last one that was there before connector was pulled. It will run > fine from that configuration.. > Changed the EEPROM, checked soldering,checked switches on front panel and > all to no removed remote receiver and still same. I haven't done the tuner > job yet, so I will try that tomorrow > Anyone have any ideas on this as its got me baffled. > Buck Pasher > Buck's TV > Gander Newfoundland > Canada > 709-256-7738 (Fax & Phone) > > > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/