Ed, there are 3 caps around the regulator IC, a 2.2uF, a 15 uF, and either a 39uF or a 47uF. Check CR4122 3.0V zener as well. Gary McCartney McCartney Electronics 7134 Fife Rd, RR 7 Guelph Ontario Canada N1H 6J4 Fax: (519)821-1530 email: number63 (at) inetsonic.com Edward Gaidies wrote: > > Have changed the Regulator Kit on this, changed the 2 small caps next to the > IC, the IC and the 470ufd, and the regulator. Set came on ran well for about > 15 minutes. Then it went off, Felt Q4101 and it had run so hot it shorted > and took out fuse again. > Anything else I should change...Kit comes with IC, Regulator, 3 Caps > (2.2....15ufd and 470ufd.) > So what did I miss, to make the Regulator run hot. > > TIA. > > -Ed- > Tel-Tek Electronics > Midland, Ontario > Canada. > teltek2@xxxxxxxxxxxx > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ -- ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/