That is normal for the ctc169 and some earlier chassis the micro holds vertical drive until after degauss You may see a faint fuzzy horizontal line across screen during degauss period. If line is more than faint turn down the G2 control Robert tvservice@xxxxxxxxxxxxx H & H Electronics Inc ----- Original Message ----- From: "Robinson Electronics" <RobinsonElectronics@xxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Thursday, September 02, 2004 12:51 PM Subject: [TechAssist] CTC169BG chassis. Has a horizontal line across the screen, when first powered on. > Has anyone seen this before? > Vertical circuit checks out good, cannot find any faults! > This set, when first turned on, has a line across the middle of the screen, > while the relay degausses, then the vertical comes up good. Does it every > time. > Any known components to check out for this? Thanks. David. > > Robinson Electronics > 1075 Sweeten Creek Road > Asheville, NC 28803 > Ph./Fax. 828 274-3787 > Toll Free. 1-888 ROBELECT > www.robinsonelectronics.com > www.robelect.com > Mailto: RobinsonElectronics@xxxxxxxxxxx > > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/