What voltages do you have at the cd pcb? Gary Carson City TV-VCR 2164 E Hwy 50 Carson City, NV 89701 (775)887-9089 fax (775)887-1067 ----- Original Message ----- From: "Scott Farley" <sfarley@xxxxxxxxxxxxx> To: "Techassist" <techassist@xxxxxxxxxxxxx> Sent: Thursday, April 04, 2002 7:13 AM Subject: [TechAssist] AIWA CX-NMT70U--CD won't spin, lens won't try to focus > > Good morning, > This bookshelf unit will take the CD, clamp it but I have no action from > the sled assy or the laser lens. If I run the sled out to the end it won't > even pull in to the stop switch. I replaced the pick-up assy, no > difference. I swapped the CD circuit board with a working unit and it still > won't work, so the problem is in the CD board assy. I replaced both the > Servo Processor, and Coil Motor Drive IC's. No change. > Does anyone have any suggestions or ideas. I am to far into this one to > let it go out unfixed. Any help will be very much appreciated. > THANKS !! SCOTT > > Midway Electronics Inc. > 1250 N McKinley Ave > Rensselaer, In. 47978 > Buis: 219-866-3716 > Fax: 219-866-7915 > Attn: (Scott-Service tech) > mailto:sfarley@xxxxxxxxxxxxx > > ------------------------------------------ > Make your TechAssist database better! > Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ > ------------------------------------------ > To UNSUBSCRIBE your email address, click here: > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > Or send a BLANK email with unsubscribe in the > SUBJECT field to the address above. > > ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above.