Ramy, You are not hearing bar numbers because the repeats are not properly matched. Every end repeat barline must have a start repeat barline unless the repeat is back to the beginning of the score. More importantly, you cannot have repeats inside other repeats. Sibelius doesn't like that at all. EG: start repeat - start repeat - end repeat - end repeat will throw the bar numbering and cause problems with playback. Dan -----Original Message----- From: sib-access-bounce@xxxxxxxxxxxxx [mailto:sib-access-bounce@xxxxxxxxxxxxx] On Behalf Of Ramy Moustafa Sent: 31 May 2012 20:07 To: sib-access@xxxxxxxxxxxxx Subject: [sib-access] sibelius can not count bars after second endings HI all: Don't know why, but I have a score here has some 1st and second endings, sibelius can count the bar numbers ok, before them, but after them, sibelius left some mesures without numbering, then continue to count, I tried the ingraving rools, to count repeat bar lines, but without success. I tried, the bar nubmer change, and I went to the bar that I need to start counting from it, but no luck also, any idea on how to achieve this? Thanks in advance Cheers: Ramy Moustafa Owner and producer of Harmony recording studios skype: roma30 Facebook: moustafa.ramy@xxxxxxxxx Twitter: Ramymoustafa youtube chanael: www.youtube.com/ramymoustafasaber If you wish to unsubscribe, send a blank message with the single word, unsubscribe - in the Subject line to: sib-access-request@xxxxxxxxxxxxx If you wish to unsubscribe, send a blank message with the single word, unsubscribe - in the Subject line to: sib-access-request@xxxxxxxxxxxxx