[SI-LIST] Re: impedance and Characteristic impedanece
- From: agathon <hreidmarkailen@xxxxxxxxx>
- To: "Kevin Ko" <wy_k@xxxxxxxxx>
- Date: Wed, 11 Apr 2007 18:53:43 -0700
Damn, boyzzzzzzz!
I'm lucky, I'm lucky, I can walk under ladders...
How many points? How about chucking in those points and $3.00 for a cup o'
coffee?
On 4/11/07, Kevin Ko <wy_k@xxxxxxxxx> wrote:
>
>
> You are right, bonus point for you! It's a brain teaser, isn't it?
> (Now I'm again at the risk of getting over 20 "out-of-office" replies)
>
> regards,
> Kevin
>
> --- agathon <hreidmarkailen@xxxxxxxxx> wrote:
>
> > The Zin = 0 for that case. Makes sense; it's the reciprocal.
> > (Same positive current defined as into CCVS.)
> >
> > The derivation is left as an exercise for .... Arpad. :-)
> > The Thevenin source is solved with KVL and you get Zin=0.
> > If you transform to Norton equivalent you get the original infinite Zin.
> >
> > These are just the native source impedances of the two types: ideal V
> > source's Zin = 0, ideal I source's Zin = infinity.
> > It seems that what either version of the problem is out to prove, by
> > isolating the source from its load through the -1 control factor.
> >
> > -Agathon
> >
> >
> > On 4/10/07, Kevin Ko <wy_k@xxxxxxxxx> wrote:
> > >
> > >
> > > Will the answer be same/different with CCVS, instead of VCCS, parallel
> to
> > > 1
> > > ohm?
> > >
> > > regards,
> > > Kevin
> > >
> > > --- "Muranyi, Arpad" <arpad.muranyi@xxxxxxxxx> wrote:
> > >
> > > > Thanks for all the great replies! I enjoyed
> > > > reading them. There are many ways to skin the
> > > > cat, right? Another analysis would be to make
> > > > a Thevenin equivalent of the circuit in which
> > > > the Thevenin source generates the same voltage
> > > > on one side of the resistor that exists on
> > > > the other side, i.e. the current through the
> > > > resistor is always zero.
> > > >
> > > > Now, regarding how this relates to the original
> > > > topic of T-line impedance:
> > > >
> > > > The resistor in this "trick question" corresponds
> > > > to the characteristic impedance of the T-line.
> > > >
> > > > The source (current for Norton, or voltage for
> > > > Thevenin) corresponds to the reflected wave in
> > > > the T-line (with zero delay). So the apparent
> > > > impedance (which I also like to call "electrical
> > > > impedance") can be calculated by looking at what
> > > > the circuit does, i.e. taking all voltage and
> > > > current relationships into account. I find this
> > > > example a good way to illustrate what goes on
> > > > in a T-line without having to go into Maxwell's
> > > > wave equations. To extend this example for
> > > > T-lines, all you have to do is add in some
> > > > delays (or phase if you do it in the frequency
> > > > domain), and you got it...
> > > >
> > > > By the way, you can turn a capacitor into an
> > > > inductor with an op-amp, configured as a NIC,
> > > > often used for making inductors on the die.
> > > > Same thing as in the above discussion, right?
> > > > You have a physical device, a capacitor, which
> > > > looks completely different in the circuit.
> > > >
> > > > We could call all of this "electrical illusions"...
> > > >
> > > > The lesson from this, which is a big pet peeve
> > > > of mine (and I have commented on this before
> > > > in this list), is that when we talk about
> > > > impedance, we must be clear which one we are
> > > > talking about. RF engineers tend to talk about
> > > > the electrical impedance as it is seen at a certain
> > > > frequency, taking into account all of the reflection
> > > > and standing wave effects, etc..., not mentioning
> > > > this underlying assumption most of the time.
> > > > Board layout guys or time domain thinkers tend
> > > > to talk about the characteristic impedance (most
> > > > often not mentioning that assumption either).
> > > >
> > > > Imagine what happens when you put these two types
> > > > of guys into the same conversation... Or imagine
> > > > what happens when a newbie takes two T-line basics
> > > > classes, one from each of these guys. Mass confusion,
> > > > total nightmare, which I have had the "pleasure" of
> > > > experiencing way too many times...
> > > >
> > > > I hope this thread helped to clarify a few basics...
> > > >
> > > > Arpad
> > > >
> > >
> >
> =3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=
> > > >
> > >
> >
> =3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=
> > > > =3D=3D=3D
> > > >
> > > > -----Original Message-----
> > > > From: Chris Padilla (cpad) [mailto:cpad@xxxxxxxxx]=20
> > > > Sent: Tuesday, April 10, 2007 9:01 AM
> > > > To: Muranyi, Arpad; si-list@xxxxxxxxxxxxx
> > > > Subject: RE: [SI-LIST] Re: impedance and Characteristic impedanece
> > > >
> > > > The main thing to notice in this simple circuit is the DEPENDENT
> SOURCE.
> > > > The amps supplied by the current source depend on the voltage
> developed
> > > > across the resistor. I'm sure too many folks glossed over that very
> > > > important detail because it appears to be such a simple, "by
> inspection"
> > > > circuit. In reality it is simple if you just note that small but
> very
> > > > important detail!
> > > >
> > > > I'll generalize the circuit a tad more:
> > > >
> > > > Let the current source be Alpha*v. Note that Alpha is in dimensions
> of
> > > > amps per volt.
> > > > Let the voltage across the current source and the resistor be v.
> > > > Let the resistor be R.
> > > >
> > > > Now, look into this circuit to figure out the input impedance. In
> > > > sophomore circuits class, we did this by "hooking on" an arbitray V
> > > > source with a labeled driving i. Figure out V/i and you have Zin.
> > > >
> > > > As my circuit theory professor would say: Now thrash around a bit!
> > > >
> > > > I did a Kirchoff's Current Law at the top node of the resistor to
> get: i
> > > > =3D Alpha*v + v/R. Note that v =3D V.
> > > >
> > > > I find that V/i =3D R/(1 + R*Alpha). Plug in R =3D 1, and Alpha =3D
> -1
> > > =
> > > > and
> > > > sure enough, V/i =3D 1/0. =20
> > > >
> > > > Note that Polarity is VERY important here!!
> > > >
> > > > Chris
> > > > ------------------------------------------------------------------
> > > > To unsubscribe from si-list:
> > > > si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject
> field
> > > >
> > > > or to administer your membership from a web page, go to:
> > > > //www.freelists.org/webpage/si-list
> > > >
> > > > For help:
> > > > si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field
> > > >
> > > >
> > > > List technical documents are available at:
> > > > http://www.si-list.net
> > > >
> > > > List archives are viewable at:
> > > > //www.freelists.org/archives/si-list
> > > > or at our remote archives:
> > > > http://groups.yahoo.com/group/si-list/messages
> > > > Old (prior to June 6, 2001) list archives are viewable at:
> > > > http://www.qsl.net/wb6tpu
> > > >
> > > >
> > > >
> > >
> > >
> > >
> > >
> > >
> > >
> >
>
> ____________________________________________________________________________________
> > > Looking for earth-friendly autos?
> > > Browse Top Cars by "Green Rating" at Yahoo! Autos' Green Center.
> > > http://autos.yahoo.com/green_center/
> > > ------------------------------------------------------------------
> > > To unsubscribe from si-list:
> > > si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field
> > >
> > > or to administer your membership from a web page, go to:
> > > //www.freelists.org/webpage/si-list
> > >
> > > For help:
> > > si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field
> > >
> > >
> > > List technical documents are available at:
> > > http://www.si-list.net
> > >
> > > List archives are viewable at:
> > > //www.freelists.org/archives/si-list
> > > or at our remote archives:
> > > http://groups.yahoo.com/group/si-list/messages
> > > Old (prior to June 6, 2001) list archives are viewable at:
> > > http://www.qsl.net/wb6tpu
> > >
> > >
> > >
> >
>
>
>
>
>
> ____________________________________________________________________________________
> Finding fabulous fares is fun.
> Let Yahoo! FareChase search your favorite travel sites to find flight and
> hotel bargains.
> http://farechase.yahoo.com/promo-generic-14795097
>
------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field
or to administer your membership from a web page, go to:
//www.freelists.org/webpage/si-list
For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field
List technical documents are available at:
http://www.si-list.net
List archives are viewable at:
//www.freelists.org/archives/si-list
or at our remote archives:
http://groups.yahoo.com/group/si-list/messages
Old (prior to June 6, 2001) list archives are viewable at:
http://www.qsl.net/wb6tpu
Other related posts:
