Crosstalk depends only on: *Aggressor signal magnitude *Aggressor signal spectrum *Interconnect geometry Given the levels of your sensor, required resolution and the amplitude of the digital aggressors you can determine what noise rejection ratio you need and design appropriately. Steve. Umamaheswar U-TLS,Chennai wrote: > Hi all, > > > > We have a design where 500Hz signals are traveling from external sensor > to the board; in the vicinity of the 500Hz signals, high frequency > signals and digitals sections are present. So I am concerned with the > signal quality( Crosstalk), is there any possibility that 500Hz signals > get affected due to the nearby high frequency signals. > > Do I need to do SI analysis on that board to know the crosstalk, or any > articles or theoretical analysis is sufficient to know the crosstalk and > any guidelines in the PCB layout will work? > > > > Please help me. > > > > Thanks in advance[Umamaheswar U-TLS,Chennai] . > > > > > > Thanks& Regards > > U.K.UMAMAHESWAR > > > > > > DISCLAIMER: > ----------------------------------------------------------------------------------------------------------------------- > > The contents of this e-mail and any attachment(s) are confidential and > intended for the named recipient(s) only. > It shall not attach any liability on the originator or HCL or its affiliates. > Any views or opinions presented in > this email are solely those of the author and may not necessarily reflect the > opinions of HCL or its affiliates. > Any form of reproduction, dissemination, copying, disclosure, modification, > distribution and / or publication of > this message without the prior written consent of the author of this e-mail > is strictly prohibited. If you have > received this email in error please delete it and notify the sender > immediately. Before opening any mail and > attachments please check them for viruses and defect. > > ----------------------------------------------------------------------------------------------------------------------- > > ------------------------------------------------------------------ > To unsubscribe from si-list: > si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field > > or to administer your membership from a web page, go to: > //www.freelists.org/webpage/si-list > > For help: > si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field > > > List technical documents are available at: > http://www.si-list.net > > List archives are viewable at: > //www.freelists.org/archives/si-list > or at our remote archives: > http://groups.yahoo.com/group/si-list/messages > Old (prior to June 6, 2001) list archives are viewable at: > http://www.qsl.net/wb6tpu > > > > -- Steve Weir Teraspeed Consulting Group LLC 121 North River Drive Narragansett, RI 02882 California office (866) 675-4630 Business (707) 780-1951 Fax Main office (401) 284-1827 Business (401) 284-1840 Fax Oregon office (503) 430-1065 Business (503) 430-1285 Fax http://www.teraspeed.com This e-mail contains proprietary and confidential intellectual property of Teraspeed Consulting Group LLC ------------------------------------------------------------------------------------------------------ Teraspeed(R) is the registered service mark of Teraspeed Consulting Group LLC ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List technical documents are available at: http://www.si-list.net List archives are viewable at: //www.freelists.org/archives/si-list or at our remote archives: http://groups.yahoo.com/group/si-list/messages Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu