Hi all, I'm guessing this has been covered in the past, but I'm hoping for a quick "been there, done that" feedback regarding laying out signal traces for LVDS circuitry using 100 ohm differential signaling. I don't have access to Linecalc so I'm hoping to get back a "typical" line width and edge to edge spacing (stripline and microstrip) to get me 100ohms differential. I'm working on a .062"-.093" (FR-4 material, 1oz CU) board stackup so line widths are variable at this point. Any and all feedback is appreciated. <---> _____________________________________________________________ ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List archives are viewable at: //www.freelists.org/archives/si-list or at our remote archives: http://groups.yahoo.com/group/si-list/messages Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu