Hello All, First off all thanks to those who spend their time writing racktables. It is much appreciated. Secondly, I have a very large number of Cisco switches and I was wondering how to get the cisco secret file to allow me to only put one entry in for all switches. I can get Racktables to show the vlans on a switch if I enter the switch name in the secrets file by its exact name. However, since all switches have a common username/pass for read only management I would like racktables to use the same account to connect to each. Thoughts? Thanks!! __________________________ Jeff Orr Network Engineer, Information Technology Genesis Healthcare Systems jorr@xxxxxxxxxxxxxx DID: 740-454-4572 | FAX: (740)450-6136 *For any IT problem, request, or question please contact the IT service desk at x4330, 740.454.4330, or ITservicedesk@xxxxxxxxxxxxxx ***Confidentiality Notice*** The information contained in this e-mail message (Cisco Switch Management) sent from (JOrr@xxxxxxxxxxxxxx ), including any attachments, are intended only for use of the individual or entity named above (racktables-users@xxxxxxxxxxxxx). This e-mail may contain information that is privileged, confidential and/or otherwise exempt from disclosure under applicable law. If the reader of this message is not the intended recipient, any disclosure, dissemination, distribution, copying or other use of the communication or its substance is prohibited. If you have received this e-mail in error, please reply to this e-mail indicating you are not the intended recipient and immediately destroy all copies of this e-mail. Receipt by anyone other than the intended recipient is not a waiver of any privileged information. Message Sent: 2010-04-08 20:55:31