Michael Healy wrote: > This enlarger is exactly as Richard describes his. The separate ground > wire is simply small-gauge wire crimped to an eyelet that was attached > to the head at one of its screws. Looking more closely, I find that this > wire's other end (about 6 feet of wire!) never was stripped for use. So > it looks like it was indeed jury-rigged, and probably never employed. I > removed it altogether for now, but I think I might give it a try and see > whether its use reduces static electricity. An awfully annoying problem > down here in central AZ. > > I think I'm not going to rewire the enlarger right now because I need > the timer, and that's 2-pronged. My darkroom has a desperate shortage of > timers, because they're all Time-o-lites and most of them will not time > correctly at times shorter than about 10 seconds. On 3-4 second times, > they simply stay on indefinitely. The copper spring inside seems no > longer to have sufficient tension to force the flywheel to complete its > circuit. So where a 2-pronged timer works, I'm using it. > > Thank you everyone! > > Mike Healy I forgot when I rewired my Time-O-Lite timer. I started with a 23C-II enlarger and it had a condenser head and a 2-wire plug. I then got an Aristo head. And later a Zone VI VC head. At some point, one of those had a 3-wire plug. I took the timer apart and put a three-wire socket on it, and a 3-wire power cord as well. Problem was that a regular 3-wire socket would not fit, so I used a Hubbell twist-lock socket instead. So I need a mating plug on whatever it was. I do ground the enlarger to reduce static. I do not know for sure if it makes any difference. -- .~. Jean-David Beyer Registered Linux User 85642. /V\ PGP-Key: 9A2FC99A Registered Machine 241939. /( )\ Shrewsbury, New Jersey http://counter.li.org ^^-^^ 08:15:01 up 6 days, 16:50, 3 users, load average: 4.49, 4.58, 4.65 ============================================================================================================= To unsubscribe from this list, go to www.freelists.org and logon to your account (the same e-mail address and password you set-up when you subscribed,) and unsubscribe from there.