-----Original Message----- >From: "Justin F. Knotzke" <jknotzke@xxxxxxxxxx> >Sent: Nov 12, 2007 4:49 AM >To: pure-silver@xxxxxxxxxxxxx >Subject: [pure-silver] Re: D 76 > >On 11/11/2007, Richard Knoppow <dickburk@xxxxxxxxxxxxx> wrote: >> >> What volume of developer are you using? >> The D-76 data sheet states that the capacity of full >> strength developer is 16 8x10 sheets or rolls of 120 film >> per gallon with the development time to be increased after >> each four rolls or sheets. >> The developer reaction products act as restrainers so >> there will be less fog but also less shadow detail as more >> film is processed. >> The capacity of developer diluted 1:1 is half the above. >> The D-76 data sheet is J-78, I believe it is still on >> the Kodak web site. > > > Thanks Richard. I am going with full strength. I don't think I've ever >done 1:1. > > I am going to soup it all tonight when the sun goes down. > > J > > >-- >Justin F. Knotzke >jknotzke@xxxxxxxxxx >http://www.shampoo.ca I was careless when writing the above. The amount of increase in time after each four sheets or rolls to the maximum is 15%. -- Richard Knoppow dickburk@xxxxxxxxxxxxx Los Angeles, CA, USA ============================================================================================================= To unsubscribe from this list, go to www.freelists.org and logon to your account (the same e-mail address and password you set-up when you subscribed,) and unsubscribe from there.