-=PCTechTalk=- Re: Fw: Jumper for CD rom

  • From: "Clinton Driggars" <driggars@xxxxxxxxxxxxx>
  • To: <pctechtalk@xxxxxxxxxxxxx>
  • Date: Sun, 28 Jul 2002 01:12:43 -0500

the way that they were lined up I could not really make since till you
described it. now it makes perfect since
Clint

----- Original Message -----
From: "Don L Elias" <donelias@xxxxxxxx>
To: <pctechtalk@xxxxxxxxxxxxx>
Sent: Saturday, July 27, 2002 11:51 PM
Subject: -=PCTechTalk=- Re: Fw: Jumper for CD rom


>
> If you look at those letters from top to down and add a few more,
> it should make sense:  It lines up better with a fixed font.
>
> CSM
> SL A
>
>  as
>  vt
>  ee
>   r
>
> Column 1 down is CS for something like Cable Select
> Column 2 down is SLave
> Column 3 down is MAster
>
> Secondary means that the device is to be connected to IDE2
> (the Secondary connector)
>
> As you should now be able to figure out, your jumper is
> set for Slave and I assume is connected to the cable that
> goes to IDE2.  You may have to change the BIOS to
> correspond with any changes you make.
>
> This is the best of my knowledge without looking into it in
> more detail.  This is the same information that is on a hard
> drive and probably your Zip Drive.  I'm not sure if the device
> on the end of the cable has to be the master or the slave,
> etc.  This should be pretty elementary for some of you
> builders.
>
> Don Elias
>
> On Sat, 27 Jul 2002 23:01:33 -0500 "Clinton Driggars"
> <driggars@xxxxxxxxxxxxx> writes:
> > Hi
> > I need to check the jumper on a CD rom in a computer that I am
> > installing a Zip Drive. I need to make sure that it is set as a
> > secondary master. The CD rom does not show what jumpers would be
> > this setting, but has some letters above them  I.E 3 sets of pins
> > Top listed CSM and below that from left to right S L A     the
> > middle pins are jumpered now which the L is above that.
> > Can someone tell me where I should put the jumpers to make it a
> > secondary master.  In the BIOS The secondary master says None and
> > the secondary slave is set as CD Rom
> > Clint
> > To unsub or change your email settings:
> > //www.freelists.org/webpage/pctechtalk
> >
> > To access our Archives:
> > http://groups.yahoo.com/group/PCTechTalk/messages/
> > //www.freelists.org/archives/pctechtalk/
>
>
> ________________________________________________________________
> GET INTERNET ACCESS FROM JUNO!
> Juno offers FREE or PREMIUM Internet access for less!
> Join Juno today!  For your FREE software, visit:
> http://dl.www.juno.com/get/web/.
> To unsub or change your email settings:
> //www.freelists.org/webpage/pctechtalk
>
> To access our Archives:
> http://groups.yahoo.com/group/PCTechTalk/messages/
> //www.freelists.org/archives/pctechtalk/

To unsub or change your email settings:
//www.freelists.org/webpage/pctechtalk

To access our Archives:
http://groups.yahoo.com/group/PCTechTalk/messages/
//www.freelists.org/archives/pctechtalk/

Other related posts: