Hi Bill, I wonder if there is a patch ready for the godunov version of cns solver. For the moment I'm using the jameson solver which runs fine, but I cannot use AMR. Cheers, Joel ----- Original Message ---- From: Bill Henshaw <henshaw@xxxxxxxx> To: overture@xxxxxxxxxxxxx Sent: Monday, December 15, 2008 7:09:45 PM Subject: [overture] Re: 3d cns Hi Joel, We have been running quite a few 3D cns cases. I know we have fixed some issues with 3d parallel AMR. It must be that there are some bugs in your version. Hopefully I will be able to put out a new version sometime soon. Regards, Bill. Joel Guerrero wrote: > By the way, > > I'm getting the same segmentation error for all cns 3d cases. It is fully > working the 3d version of the cns solver? > > Joel > > > ----- Original Message ---- > From: Joel Guerrero <joegi.geo@xxxxxxxxx> > To: overture@xxxxxxxxxxxxx > Sent: Sunday, December 14, 2008 10:08:59 PM > Subject: [overture] 3d cns > > Hi, I'm trying to run a 3d case using cns but I-m getting this error. > > 0.000e+00 gamma=1.400e+00 > a=1.00e+00, b=0.00e+00, c=0.00e+00, d=2.50e-01, stepPosition = 2.500000e-01, > stepSharpness=0.000000e+00 uLeft = > [2.667e+00,1.250e+00,0.000e+00,0.000e+00,1.205e+00,] > uRight = [1.000e+00,0.000e+00,0.000e+00,0.000e+00,7.144e-01,] > assignIC: step function: grid=0 stepNormal=( 1.00e+00, 0.00e+00, 0.00e+00), > stepNormalEquationValue= 2.50e-01 > continue > debug > 1 7 31 > debug=1 > continue > ---assigning reynoldsNumber to match mu---- > ---assigning machNumber to match Rg---- > inside DomainSolver::setup > DomainSolver::initialize: numberOfGridFunctionsToUse= 2, > numberOfExtraFunctionsToUse=1 +++++DomainSolver::initialize: > cg.numberOfComponentGrids=1 ++++++++++++++ > **** Build AMR levels for the initial conditions... ***** > interpolateAndApplyBoundaryConditions (start) steps=-1 t=0: number of array > ID's has increased to 498 > Overture::checkMemoryUsage: interpolateAndApplyBoundaryConditions (start) > steps=-1 t=0, myid=0: memory usage has increased to 21.1523 (Mb) > *****Build AMR level = 1 Segmentation fault > > > I get this error trying to run the shockTube3d.cmd testcase included in the > cg distributuion, any idea what could be the error? > > > Regards, > > Joel > > > >