Re: Add/remove RAC nodes and GC

  • From: Freek D'Hooge <freek.dhooge@xxxxxxxxx>
  • To: cichomitiko@xxxxxxxxx
  • Date: Sat, 31 May 2014 08:43:17 +0200

I just configured new exadata nodes in OEM 12c (R3) yesterday.
The way I did it was to first add the nodes to the cluster and
afterwards configuring them in OEM.

High level steps done where:

* add the host targets
* Modify the cluster target monitoring configuration to add the new
nodes to the existing cluster
* Add the Oracle Homes, listener, ... through the "add manual targets
using guided procedure"

No problems encountered and all targets showed up correctly.

For the node removal, I'm not sure what would be the best.
Maybe 

* remove the db instances from the old nodes
* Remove the instances in OEM
* drop the nodes from the cluster
* Modify the cluster target monitoring configuration to reflect the node
drop
* Remove the host targets in OEM (and recursively let it delete the
oracle homes, .... targets)
* Remove the agent / agent home targets in OEM
* Scratch the old servers

Kind regards,

-- 
Freek D'Hooge
Exitas NV
Senior Oracle DBA
email: freek.dhooge@xxxxxxxxx
tel +32(03) 443 12 38
http://www.exitas.be 

On vr, 2014-05-30 at 13:54 +0200, Radoulov, Dimitre wrote:

> Hi list,
> 
> RAC 11.2.0.3.5 on RHEL 5.9
> GC 11g
> 
> We need to move some RAC nodes to new servers and we plan to do it by 
> adding new nodes and removing the old ones.
> The EM GC agents are already installed and configured on the existing nodes.
> 
> Should I install and configure the agents on the new nodes before or 
> after adding them to the cluster?
> I suppose both are possible, but I'm looking for the best/easiest way.
> And what about the nodes to be removed: stop/deconfigure the targets 
> before or after the node removal?
> 
> Your ideas and suggestions are welcome!
> 
> 
> Regards
> Dimitre
> --
> //www.freelists.org/webpage/oracle-l
> 
> 

Other related posts: