In that case I see a motion problem. If original film is captured with 24 frames/sec and converted to 1080p/60 frames/sec for display - the motion will have 2/3 pull down type of motion jitter. On the other hand 24 frames/sec film displayed at 72 Hz or 96 Hz will not have such problems. So what is the point to display 1080p/60 in the movie theater? Best Regards, Mike Tsinberg Key Digital Systems Cell: 646-391-7537 email:mike@xxxxxxxxxxxxxx http://www.keydigital.com -----Original Message----- From: Tom Barry [mailto:trbarry@xxxxxxxxxxx] Sent: Monday, August 31, 2009 01:51 PM To: opendtv@xxxxxxxxxxxxx Subject: [opendtv] Re: 1080P Question Mike Tsinberg wrote: > In consumer markets Blu Ray recording format is limited to 1080p/24, 1080i/60 or 720p. The 1080p/60 is not format that stored on Blu Ray. As far as Master Format I am sure it is the best. But practically is it use for that purpose in production and postprodcution. After all it is far more expensive to create 1080p/60 then 1080i/60 or 1080p/24. For theatrical release I was under impresionthat 1080p/24 is ideal because it is displayed at 1080p/72 in the digital theaters. The 1080p/60is actually hindernce for that purpose. > > > Best Regards, > Mike Tsinberg > Key Digital Systems > Cell: 646-391-7537 > email:mike@xxxxxxxxxxxxxx > http://www.keydigital.com > I don't remember the details (I think AVS forum) but recently I read somewhere that some of the newer digital theaters can display 1080p/60 as a native frame rate. Can anyone confirm this? - Tom ---------------------------------------------------------------------- You can UNSUBSCRIBE from the OpenDTV list in two ways: - Using the UNSUBSCRIBE command in your user configuration settings at FreeLists.org - By sending a message to: opendtv-request@xxxxxxxxxxxxx with the word unsubscribe in the subject line.