Hi, It took me bit longer as expected but I managed to unearth some info. The engine type you seem to have seems to have a carburettor which I so far only saw on engines with a horizontal crank axle. I have never seen it fitted to a vertical engine. Anyway I found the type on an old micro film and managed to find the general BR&STR manual in Dutch. Since I the list does not take attachments I will scan some info and send it direct to your address. The later method will save considerably on ferry costs. Speaking of lather, why can I drive for free into France, Germany, Holland and Luxemburg and have to pay to go into England? See if I can find some time this weekend to sort the info out. Regards Wilfried Vermeiren http://users.skynet.be/modelbouw.wilfried -----Oorspronkelijk bericht----- Van: modeleng-bounce@xxxxxxxxxxxxx [mailto:modeleng-bounce@xxxxxxxxxxxxx] Namens Patrick Coppens-Marian Lynch Verzonden: vrijdag 4 november 2005 15:23 Aan: modeleng@xxxxxxxxxxxxx Onderwerp: [modeleng] briggs and stratton, take 2 Thanks everybody for the info so far! Wilfried, the numbers you spoke of ar the following: Model 130902 Type 0536 01 Code 79031306 al info greatfully accepted.. Patrick MODEL ENGINEERING DISCUSSION LIST. To UNSUBSCRIBE from this list, send a blank email to, modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line. MODEL ENGINEERING DISCUSSION LIST. To UNSUBSCRIBE from this list, send a blank email to, modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.