[Linux-Anyway] 19" CRT Monitor setup in SW9.1
- From: John Richard Smith <BAGSOFCHOICE@xxxxxxxxxxxxxxxxxxxxx>
- To: Linux-Anyway@xxxxxxxxxxxxx
- Date: Wed, 03 Nov 2004 19:51:18 +0000
I have a new 19" CRT monitor
which I have set up with the use of xf86config in Slackware 9.1.
This monitor is rated
1600x1200 @ 75Hz
1280x1024 @ 85 Hz
I set it up as,
1600x1200
which is fair enough
but I'm sure I'm only geting 60Hz
I feel reasonably sure SW91 can do
1600x1200 @ 75Hz but I don't seem able to get it. Here is the monitor
section
/etc/X11/xf86config
# **********************************************************************
# Monitor section
# **********************************************************************
# Any number of monitor sections may be present
Section "Monitor"
Identifier "AOC"
# HorizSync is in kHz unless units are specified.
# HorizSync may be a comma separated list of discrete values, or a
# comma separated list of ranges of values.
# NOTE: THE VALUES HERE ARE EXAMPLES ONLY. REFER TO YOUR MONITOR'S
# USER MANUAL FOR THE CORRECT NUMBERS.
# HorizSync 1600x1200 @ 75 Hz
HorizSync 31.5-79
# HorizSync 30-64 # multisync
# HorizSync 31.5, 35.2 # multiple fixed sync frequencies
# HorizSync 15-25, 30-50 # multiple ranges of sync frequencies
# VertRefresh is in Hz unless units are specified.
# VertRefresh may be a comma separated list of discrete values, or a
# comma separated list of ranges of values.
# NOTE: THE VALUES HERE ARE EXAMPLES ONLY. REFER TO YOUR MONITOR'S
# USER MANUAL FOR THE CORRECT NUMBERS.
VertRefresh 50-90
EndSection
Is this about all correct ?
Isn't VertRefresh 50-90 where the parameter are set ?
What should I change if anything ?
John
To unsubcribe send e-mail with the word unsubscribe in the body to:
Linux-Anyway-Request@xxxxxxxxxxxxx?body=unsubscribe
Other related posts:
