[PCB_FORUM] Re: single pin nets
- From: "richard moffat" <richard.moffat@xxxxxxxxxxxxxxxxxxx>
- To: <icu-pcb-forum@xxxxxxxxxxxxx>
- Date: Tue, 28 Jun 2005 09:36:07 +1200
You need
axlCmdRegister("spnchk" 'Single_Pin_Net_Check_Routine ?cmdType "interactive")
in your allegro.illinit file .
Then 'spnchk' in your Allegro command-line window.
__________________________
Richard Moffat
PCB CAD Manager
Allied Telesyn Research Ltd, NZ.
ph. +64 (3) 3393000
richard.moffat@xxxxxxxxxxxxxxxxxxx
>>> jack.kelly@xxxxxxxxxx 28/06/2005 9:24:13 a.m. >>>
what is the correct syntax to get this skill file to load in my allegro.illinit
file. it was written by David J. Scheuring
NOTICE: This message contains privileged and confidential
information intended only for the use of the addressee
named above. If you are not the intended recipient of
this message you are hereby notified that you must not
disseminate, copy or take any action in reliance on it.
If you have received this message in error please
notify Allied Telesyn Research Ltd immediately.
Any views expressed in this message are those of the
individual sender, except where the sender has the
authority to issue and specifically states them to
be the views of Allied Telesyn Research.
Other related posts:
