[PCB_FORUM] Suppress unconnected pins necessary?
- From: "Kumaran" <m.kumaran@xxxxxxxxxxxxx>
- To: <icu-pcb-forum@xxxxxxxxxxxxx>
- Date: Thu, 17 Mar 2005 11:05:30 +0530
What are the Merits & Demerits of supressing unconnected pins? When i generate
the gerbers for inner layers,is that necessary to check suppress unconnected
pads option enabled?
Regards
Kumaran
--
This message contains information from GDA Technologies LTD and affiliates,
and is intended for the sole use of the individual and entity to whom it is
addressed. It may contain information, including any attachments, that is
privileged, confidential and exempt from disclosure under applicable law. If
you are not the intended addressee, nor authorized to receive for the intended
addressee, you are hereby notified that you may not use, copy, disclose or
distribute to anyone the message or any information contained in the message.
If you have received this electronic transmission in error, please notify the
sender immediately by a "reply to sender only" message and destroy all
electronic and hard copies of the communication, including attachments.
This message was scanned for spam and viruses by BitDefender.
Other related posts:
