[PCB_FORUM] תשובה: Re: from amin
- From: "Amin Aslan" <amin@xxxxxxxxx>
- To: <icu-pcb-forum@xxxxxxxxxxxxx>
- Date: Tue, 12 Apr 2005 14:12:27 +0200
Thank you david, ( about edge connectors) ; but why do I nees to make top pad
buried/blind ??
_____
מאת: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] בשם David Greig
נשלח: Tuesday, April 12, 2005 10:31 AM
אל: icu-pcb-forum@xxxxxxxxxxxxx
נושא: [PCB_FORUM] Re: from amin
Amin
Define top (pad only on begin layer) and bottom (pad only on end layer)
surface pads, each set as blind/buried.
Best Regards
David Greig
_____
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Amin Aslan
Sent: 2005-April-12 10:11
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] from amin
I AM USING CADENCE 15.2 AND I AM DESIGNING AN EDGE CONNECTOR : SMD PINS ON TOP
AND SMD PINS ON BOTTOM… HOW DO I DESIGN AN SMD PIN ON BOTTOM ?? I
CANNOR MIRROR PINS……ON SMD PINS THERE IS NO BOTTOM LAYER…………… THANKS AHEAD
--
Virus scanned by Lumison.
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.308 / Virus Database: 266.9.6 - Release Date: 4/11/2005
--
No virus found in this incoming message.
Checked by AVG Anti-Virus.
Version: 7.0.308 / Virus Database: 266.9.6 - Release Date: 4/11/2005
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.308 / Virus Database: 266.9.6 - Release Date: 4/11/2005
Other related posts:
