Amin This is just a little anomaly in one of the most powerful layout tools available. With Allegro there is always some way to achieve the desired result, usually very efficiently! Best Regards David Greig _____ From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Amin Aslan Sent: 2005-April-12 13:12 To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] תשובה: Re: from amin Thank you david, ( about edge connectors) ; but why do I nees to make top pad buried/blind ?? _____ מאת: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] בשם David Greig נשלח: Tuesday, April 12, 2005 10:31 AM אל: icu-pcb-forum@xxxxxxxxxxxxx נושא: [PCB_FORUM] Re: from amin Amin Define top (pad only on begin layer) and bottom (pad only on end layer) surface pads, each set as blind/buried. Best Regards David Greig _____ From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Amin Aslan Sent: 2005-April-12 10:11 To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] from amin I AM USING CADENCE 15.2 AND I AM DESIGNING AN EDGE CONNECTOR : SMD PINS ON TOP AND SMD PINS ON BOTTOM… HOW DO I DESIGN AN SMD PIN ON BOTTOM ?? I CANNOR MIRROR PINS……ON SMD PINS THERE IS NO BOTTOM LAYER…………… THANKS AHEAD -- Virus scanned by Lumison. -- No virus found in this outgoing message. Checked by AVG Anti-Virus. Version: 7.0.308 / Virus Database: 266.9.6 - Release Date: 4/11/2005 -- Virus scanned by Lumison. -- No virus found in this incoming message. Checked by AVG Anti-Virus. Version: 7.0.308 / Virus Database: 266.9.6 - Release Date: 4/11/2005 -- No virus found in this outgoing message. Checked by AVG Anti-Virus. Version: 7.0.308 / Virus Database: 266.9.6 - Release Date: 4/11/2005