Dal, Contact Mike Wilson at 215-368-5817, He has been quite helpful for these types of interfaces for me. Carl ________________________________ From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of dalocke2 Sent: Saturday, March 18, 2006 11:14 AM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Re: Orcad capture 2 concept con2cap Hello, I am "trying" to convert some high pin count concept symbols to ORCAD capture using the con2cap command. I run the command exactly how the help page says and I get nothing. I don't get a message from the window or any output at all. Has anyone been sucessful in this? If so, would you please tell me how you did it? Thanks, Dal