[PCB_FORUM] Logo on Top Etch layer
- From: Gennadiy Kiryukhin <genna@xxxxxxxxxxxxxxx>
- To: icu-pcb-forum@xxxxxxxxxxxxx
- Date: Fri, 26 May 2006 10:26:17 -0400
Greetings everybody,
I have a company logo created as a mechanical symbol using shapes on the
top etch layer.
When I place the symbol onto my board it gives me a DRC error because
some of the shapes are too close to each other (even though the same-net
DRC is turned off). To remove the DRC error, after I place the symbol, I
manually reassign the shape to some other valid net like GND and after
that I reassign it back to a dummy net (back to what it was). That
clears my DRC errors.
Does anybody know of any way to create a symbol such that the DRC error
would not be in the first place. I just hate to go and reset the net
assignment every time I place the symbol.
Gennadiy Kiryukhin
Development Engineer
ATSI
-----------------------------------------------------------
To subscribe/unsubscribe:
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe
To view the archives of this list go to
//www.freelists.org/archives/icu-pcb-forum/
Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------
Other related posts: