Thank you. I realize that I wasn't sorting the post correctly. _____ From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Linda Meyer Sent: Wednesday, November 07, 2007 6:13 PM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Re: Job postings Jim, the post that you observed from 2006 was the initial posting on "how to use the forum" by the administrator. the most recent job posting was on October 7 of this year. You might also note that most of the job postings have received over 1000 views. You are certainly welcome to post both on cdnusers.org and on Freelists. or one or the other. Linda Meyer administrator www.cdnusers.org _____ From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Jim Wages Sent: Wednesday, November 07, 2007 3:05 PM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Re: Job postings Thanks for the link. I didn't even know about that sub-forum, or how to get to it, but the most recent job posting is from 2006. I sincerely intend no offense what so ever, but as a member of this "freelist" I would much prefer to have employment opportunities listed here. I have posted job sharing opportunites here when I get a bit overloaded and have had some good and quick turn replies and experiences. Jim Wages SR. PCB Layout Designer Cary, NC _____ From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Macindoe, Gary Sent: Wednesday, November 07, 2007 5:43 PM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Re: Job postings Dale, Here it is on the Cadence users site: http://www.cdnusers.org/Forums/tabid/52/view/topics/forumid/76/Default.aspx Good luck! Gary E. MacIndoe PCB Design Engineer Fort Collins, Colorado amd.com gary.macindoe@xxxxxxx _____ From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Dale Rasmusen Sent: Wednesday, November 07, 2007 2:27 PM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Job postings All, Can anyone point me to the site so I can post a job opening for an Allegro designer? Thanks, Dale Rasmusen Senior CAD Engineer TEKNOVUS (707) 665-0400 ext 133 (707) 665-0491 fax